Kohler K-1913-R-96 Przewodnik Instalacji Pobierz pdf (Strona 16)

8. Position the Bath

All Installations

IMPORTANT! If the installation site is in an area where frequent or prolonged power outages occur, it is

recommended that a minimum 350 VA Uninterruptible Power Supply (UPS) be installed as a backup

power source.

IMPORTANT! If a handshower is being installed, follow the instructions packed with the handshower.

Make sure the handshower installation conforms to all applicable backﬂow prevention requirements.

Install any valving or accessories.

Adjust each of the six leveling feet until they extend 1/4″ (6 mm) to 1/2″ (1.3 cm) from the frame.

Install the grab bar and slotted overﬂow drain following their installation instructions. If the PVC

pipe included with the drain is too short, cut a new length using commonly available 1-1/2″

Schedule 40 PVC pipe.

If a UPS backup power supply is being installed, install it now following the UPS manufacturer’s

instructions. Do not connect the power source to the UPS at this time.

Reassemble the Bath

NOTE: The following steps are not required if you did not disassemble the bath. If the bath has not been

disassembled, proceed to ″Move the Bath Into the Stud Pocket″ steps below.

Cover the area of the bathroom ﬂoor where the bath will be reassembled with protective material.

Move the bath and support frame from the staging area to the installation area.

If the bath was removed from the frame, carefully position the bath on the frame.

Make sure each of the wood support feet are positioned correctly in the corresponding bracket.

Attach the bath to the support frame.

Bracket

Wood Block (4)

Bottom View

Leveling Foot Locations

Install the bath to the frame.

1128532-2-C 16 Kohler Co.

1 2 ... 11 12 13 14 15 16 17 18 19 20 21 ... 135 136

Brak uwag

Kohler K-1913-R-96 Przewodnik Instalacji Strona 16