Kohler COMMAND20=25HP Instrukcja Użytkownika

0 WNER 's MANUAL COMMAND 20=25 HP HOREONUL CRANKSHAFT LP Gas Fueled or Dual-Fueled (LP Gas - Gasoline) -- RUN'"

Oil SentryTM Some engines are equipped with an optional Oil Sentry’” oil pressure switch. If the oil pressure decreases below an acceptable level, the

8. Test run the engine to check for leaks. Stop the engine, allow a minute for the oil to drain down, and recheck the level on the dipstick. Add more

7. When element replacement is necessary order genuine Kohler parts. I CH20-22 I CH25 I I 47083034 I 2408303-S I Clean Air Intake/Cooling Areas To en

Fuel Filter The filter of the LP fuel system is an integral part within the lock-off/filter assembly. All service relating to the lock-off/filter is

4. Reinstall plug using Teflon@ pipe sealant (not Teflon@ tape) on threads and tighten securely. If required, a replacement plug is available as Kohle

Storage When the engine is not in use, use the following storage procedure. Federal, state, or local laws governing LPG fuel tank storage may also app

LIMITED 2 YEAR COMMAND ENGINE WARRANTY We warrant to the original consumer that each new Command engine sold by us will be free from manufacturing def

(c) For warranty repairs, the engine must be presented to a Kohler Co. service center as soon as a problem exists. Call 1-800-544-2444 or access our w

Safety Precautions To insure safe operations please read the following statements and understand their meaning. Also refer to your equipment owner&ap

FOR SALES AND SERVICE INFORMATION IN US. AND CANADA, CALL 1-800-544-2444 60- 110 RUN'" ENGINE DIVISION, KOHLER CO., KOHLER, WISCONSIN 53044

Safefy Precautions (Conf.) GasoEne is extremely flammable and its vapors can explode if ignited. Store gasoline only in approved containers, in well v

Air Cleaner Dipstick , ! tric / si :igure I, Typical Command Horizontal Shaft LP Gas Fueled Engine, Oil Recommendations Using the proper type and weig

LPG Engines LPG Fuel Recommendations Liquefied Petroleum Gas (LPG) from an appropriate LP fuel tank (supplied separately) is required to operate this

Engine Identification Numbers When ordering parts, or in any communication involving an engine, always give the Model, Specification, and Serial Numbe

Starting 1. Place the throttle control in the idle position. Place the choke control into the “on”position. See Figure 5. On dual-fueled engines, pla

Battery A 12 volt battery is normally used. Refer to the operating instructions of the equipment this engine powers for specific battery requirements

Maintenance Schedule These required maintenance procedures should be performed at the frequency stated in the table. They should also be included as p